Betekenis van:
power meter

Voorbeeldzinnen

1. The output power of a one square meter solar panel is about one watt, so it is difficult to use solar power on a large scale at present.
2. Set the power meter current range.
3. Allow the readings on the power meter to stabilise and then take the true power reading in watts from the power meter.
4. This necessitates the use of a True RMS power or energy meter.
5. Plug the UUT into the measurement power outlet on the meter.
6. No power strips or UPS units should be connected between the meter and the UUT.
7. The meter should be able to store and output the maximum power measurement reached during the test or be capable of another method of determining maximum power.
8. For the test to be valid the meter should remain in place until all Off, Sleep, and Idle power data is recorded.
9. Reset the meter (if necessary) and begin accumulating true power values at an interval of at least one reading per second.
10. Connect an approved meter capable of measuring true power to an AC line voltage source set to the appropriate voltage/frequency combination for the test.
11. Set the meter to begin accumulating true power values at an interval no more than one reading per second, and begin taking measurements.
12. The goal of the test procedures is to accurately measure the TRUE power consumption [6] of the product. This necessitates the use of a True RMS power or energy meter.
13. With the UUT shut down and in Off, set the meter to begin accumulating true power values at an interval of less than or equal to one reading per second.
14. The maximum duty cycles for the meter reading systems and tracing and asset tracking system in the low power part of the 169,4 – 169,8125 MHz radio spectrum band shall be < 10 % and < 1 % respectively.
15. Between five and 15 minutes after the initial boot or log in, set the meter to begin accumulating true power values at an interval of at least one reading per second.